Communicate with Supplier? Supplier
Myron Zhu Mr. Myron Zhu
What can I do for you?
Chat Now Contact Supplier

Shijiazhuang BKDR Metallurgical Science & Technology Co.,Ltd


Home > News > Installation of Slurry Pump

Installation of Slurry Pump


The assembly precision of CMZ Slurry Pump internal components must be in accordance with the standards, including the impeller, seal and bearing; in the transport process, will inevitably cause the internal components of slurry pump loose, therefore, the pump is mounted to the base, to find it leveling. The outlet and entrance of the slurry pump are connected and the stress will be produced after the pipe is broken. If the alignment is not good, it is easy to cause radial movement, shaft vibration and shaft deviation in the operation, so that the power consumption increases, the bearing and sealing wear, and shorten the service life.

In order to improve the suction performance of slurry pump, the suction line should be as short as possible to minimize the bend pipe pump (preferably with large curvature radius elbow), in order to reduce the resistance loss of pipeline. In order to prevent the pump from cavitation, the pump suction line should be as much as possible to avoid accumulation of gas bladder shaped parts, can not be avoided, should be located in the sac shaped exhaust valve. When the suction pipe of the pump is vertical, if the suction pipe is equipped with a reducer, it should be equipped with eccentric reducer, so as not to form the airbag
Related Products List